Oil Pump Installation Note (SKYACTIV-G 2.0)

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

Install the oil pump using the following procedure:

Temporarily tighten the three bolts shown in the figure.

Fig 1: Installing Oil Pump Bolts
Courtesy of MAZDA MOTORS CORP.
Tighten the two bolts shown in the figure to the specified torque.

Fig 2: Oil Pump Bolts Tightening Sequence - Two Bolts
Courtesy of MAZDA MOTORS CORP.
NOTE:
- The tightening order for the two bolts is optional.
Tightening torque

20-26 N.m {2.1-2.6 kgf.m, 15-19 ft.lbf}
Finally, tighten the bolt shown in the figure to the specified torque.

Fig 3: Oil Pump Bolts Tightening Sequence
Courtesy of MAZDA MOTORS CORP.

Tightening torque

20-26 N.m {2.1-2.6 kgf.m, 15-19 ft.lbf}