LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 119 (Control System - Auto A/C) >> Airflow Mode Actuator Removal/Installation (Auto A/C) >> Removal

Airflow Mode Actuator Removal/Installation (Auto A/C): Removal

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
  2. Remove the glove compartment. (See GLOVE COMPARTMENT REMOVAL/INSTALLATION .)
  3. Disconnect the airflow mode actuator connector.
  4. Remove the screws.
    Fig 1: Removing Airflow Mode Actuator Connector
    G11529295Courtesy of MAZDA MOTORS CORP.
  5. Remove the airflow mode actuator.
  6. Remove the airflow mode main link.
    Fig 2: Removing Airflow Mode Actuator
    G11529296Courtesy of MAZDA MOTORS CORP.
  7. Remove the brackets.
    Fig 3: Removing Airflow Mode Actuator Brackets
    G11529297Courtesy of MAZDA MOTORS CORP.
  8. Install in the reverse order of removal. (See REMOVAL .)
scientia non olet · About LEMON Manuals