LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 119 (Control System - Auto A/C) >> Air Mix Actuator Removal/Installation (Auto A/C) >> Passenger-side

Air Mix Actuator Removal/Installation (Auto A/C): Passenger-side

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
  2. Remove the following parts:
    1. Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION .)
    2. Dashboard under cover (See DASHBOARD UNDER COVER REMOVAL/INSTALLATION .)
    3. Side wall (passenger-side) (See SIDE WALL REMOVAL/INSTALLATION .)
    4. Front heat duct (passenger-side) (See FRONT HEAT DUCT REMOVAL/INSTALLATION .)
  3. Disconnect the connector.
    Fig 1: Disconnecting Air Mix Actuator Connector - Passenger-Side
    G11529292Courtesy of MAZDA MOTORS CORP.
  4. Remove the screws.
  5. Remove the passenger-side air mix actuator.
  6. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals