LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 117 (Instrumentation/Driver Info) >> Active Driving Display Removal/Installation >> Replacing Active Driving Display as Single Component

Replacing Active Driving Display as Single Component

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Upper column cover (See COLUMN COVER REMOVAL/INSTALLATION .)
    2. Meter hood (See METER HOOD REMOVAL/INSTALLATION .)
    3. Instrument cluster (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .)
  3. Remove the screws.
    Fig 1: Removing Screws
    G11564698Courtesy of MAZDA MOTORS CORP.
  4. Disconnect the connector.
    Fig 2: Detaching Connector
    G11564699Courtesy of MAZDA MOTORS CORP.
  5. Remove the active driving display.
  6. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals