Disc Plate Thickness Inspection

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Excessive runout may result if the disc plate is removed from the vehicle then machined. Machine the disc plate while installed on the vehicle.

Remove the wheel and tire. (See WHEEL AND TIRE REMOVAL/INSTALLATION .)
Measure the thickness of the disc plate.
Minimum front disc plate thickness

23.0 mm {0.906 in}

Minimum front disc plate thickness after machining using a brake lathe on-vehicle

23.8 mm {0.937 in}
- If the thickness is not within the specification, replace the disc plate. (See FRONT BRAKE (DISC) REMOVAL/INSTALLATION .)