LED Illumination Inspection
WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
- Remove the glove compartment. (See GLOVE COMPARTMENT REMOVAL/INSTALLATION .)
- Remove the decoration panel. (See DECORATION PANEL REMOVAL/INSTALLATION .)
- Apply battery voltage to hazard warning switch terminal A, and connect terminal B to ground.
- Verify that the LED is turned on.
- If the LED does not turn on, replace the hazard warning switch. (See HAZARD WARNING SWITCH REMOVAL/INSTALLATION .)