LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 111 (Seat Belt) >> Seat Belt Inspection >> ELR (Emergency Locking Retractor) >> Rear center seat belt (Hatchback (5HB))

Rear center seat belt (Hatchback (5HB))

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • The rear center seat belt ELR only becomes operable after a certain amount of belt webbing is pulled out. For the ELR inspection, fasten the rear center seat belt to the rear buckle (center) and perform the inspection after pulling out the rear center seat belt 130 mm {5.12 in} (ELR operable condition). If the inspection is performed while the ELR is not in an operable condition, the integrity of the system cannot be determined.
  1. Fasten the rear center seat belt to the rear buckle (center) and pull out the rear center seat belt 130 mm {5.12 in}.
    Fig 1: Fastening Rear Center Seat Belt
    G11428680Courtesy of MAZDA MOTORS CORP.
  2. Verify that the belt can be pulled out smoothly, and that it retracts smoothly.
  3. Verify that the retractor locks when the belt is pulled quickly.
  4. Remove the retractor. (See REAR CENTER SEAT BELT REMOVAL/INSTALLATION .)
  5. While pulling the seat belt out, make sure that the seat belt does not lock when the retractor is tilted slowly up to 15° from the mounted position and locks when the retractor is tilted 40° or more.
    Fig 2: Removing Retractor
    G09076258Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals