Diagnostic procedure
WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
| STEP | INSPECTION | ACTION | |||
|---|---|---|---|---|---|
| 1 | VERIFY WHETHER MALFUNCTION IS PAST OR PRESENT
|
Yes | Perform DTC inspection and go to the applicable DTC troubleshooting procedure. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .) After completing the applicable DTC troubleshooting, go to the next step. |
||
| No | Clear the DTC from the memory and go to the Step 3. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .) |
||||
| 2 | PERFORM EPS CONTROL MODULE DTC INSPECTION
|
Yes | Go to the applicable DTC inspection. (See ELECTRIC POWER STEERING (EPS) ON-BOARD DIAGNOSIS [ELECTRIC POWER STEERING (EPS)] .) |
||
| No | Go to the next step. | ||||
| 3 | VERIFY THAT THE SAME DTC IS NOT PRESENT
|
Yes | Repeat the inspection from Step 1. If the malfunction recurs, replace the DSC HU/Control Module, then go to the next step. (See DSC HU/CONTROL MODULE REMOVAL/INSTALLATION .) |
||
| No | Go to the next step. | ||||
| 4 | VERIFY THAT NO OTHER DTCS ARE PRESENT
|
Yes | Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .) |
||
| No | DTC troubleshooting completed. | ||||
|
|||||