LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Security And Locks) >> Rear Door Lock Actuator Inspection >> LH

Rear Door Lock Actuator Inspection: LH

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fully lower the rear door glass.
  2. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
  3. Remove the following parts:
    1. Rear door trim (See REAR DOOR TRIM REMOVAL/INSTALLATION .)
    2. Rear inner handle (See INNER HANDLE REMOVAL/INSTALLATION .)
    3. Rear door speaker (See REAR DOOR SPEAKER REMOVAL/INSTALLATION .)
    4. Rear power window motor (See REAR POWER WINDOW MOTOR REMOVAL/INSTALLATION .)
    5. Rear door quarter glass (See REAR DOOR QUARTER GLASS REMOVAL/INSTALLATION .)
    6. Rear door glass (See REAR DOOR GLASS REMOVAL/INSTALLATION .)
    7. Rear door latch and lock actuator (See REAR DOOR LATCH AND LOCK ACTUATOR REMOVAL/INSTALLATION .)
  4. Apply battery positive voltage and connect the ground to the rear door lock actuator terminals as indicated in the table below and verify the operation condition.
    Fig 1: Connecting Ground To Rear Door Lock Actuator Terminals
    G11467786Courtesy of MAZDA MOTORS CORP.
    B+ Terminal Ground Terminal Operation
    A G Lock
    G A Unlock
    • If not as indicated in the table, replace the rear door latch and lock actuator.
scientia non olet · About LEMON Manuals