LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Security And Locks) >> Fuel-Filler Lid Opener And Lever Removal/Installation >> Fuel-filler Lid Opener >> Sedan (4SD)

Sedan (4SD)

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pull back the trunk side trim (LH) to a position which allows for the removal of the fuel-filler lid opener. (See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
  2. Open the fuel-filler lid.
  3. Remove the nut.
    Fig 1: Locating Fuel-Filler Lid Opener Nut
    G09077004Courtesy of MAZDA MOTORS CORP.
  4. While pressing the tabs of the stopper bracket in the direction of arrow (1) shown in the figure, press it in the direction of arrow (2) to detach it from the body.
    Fig 2: Pressing Stopper Bracket Tabs
    G11467699Courtesy of MAZDA MOTORS CORP.
  5. Detach all the stopper bracket tabs from the body and remove the stopper bracket.
  6. Remove the fuel-filler lid opener in the direction of the arrow.
    Fig 3: Removing Fuel-Filler Lid Opener
    G11467700Courtesy of MAZDA MOTORS CORP.
  7. Disconnect the fuel-filler lid opener cable from the fuel-filler lid opener.
    Fig 4: Disconnecting Fuel-Filler Lid Opener Cable From Fuel-Filler Lid Opener
    G11467701Courtesy of MAZDA MOTORS CORP.
  8. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals