Pre-Delivery Inspection Table: Exterior
WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
INSPECT and ADJUST, if necessary, the following items to specification:
- Glass, exterior bright metal and paint for damage
- Wheel lug nuts
- All weatherstrips for damage or detachment
- Adjust tire pressures to specification
- Adjust the tire pressures when the tires are cool.
- Specified pressure is indicated on the door label.
| Tire pressure record | ||||
| Left front | Right front | Left rear | Right rear | Spare |
- After adjusting the tire pressures, switch the ignition ON (engine off or on) and long-press the tire pressure monitoring system set switch until the tire pressure warning light flashes two times and the buzzer sounds one time (with tire pressure monitoring system switch).
| Indicated that long-pressing of the tire pressure monitoring system set switch was implemented |
| Yes or No |
- Headlight cleaner and fluid level (if equipped)
- Operation of hood release and lock
- Operation of fuel-filler lid opener
- Door operation and alignment including side door and back door
- Headlight aiming
INSTALL the following parts:
- Wheel caps or rings (if equipped)