After road test
WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
INSPECT for necessary owner information materials, tools, and spare tire in vehicle The following items must be completed just before delivery to your customer.
- Load test battery and charge if necessary (Load test result: Volts)
- Adjust tire pressures to specification
- Adjust the tire pressures when the tire are cool.
- Specified pressure is indicated on the door label.
| Tire pressure record | ||||
| Left front | Right front | Left rear | Right rear | Spare |
- After adjusting the tire pressures, switch the ignition ON (engine off or on) and long-press the tire pressure monitoring system set switch until the tire pressure warning light flashes two times and the buzzer sounds one time (with tire pressure monitoring system switch).
Indicated that long-pressing of the tire pressure monitoring system set switch was implemented Yes or No - Clean outside of vehicle
- Remove seat and cabin carpet protective covers
- Vacuum inside of vehicle