Wiring Harness

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

To remove the wiring harness from the clip in the engine room, pry up the hook of the clip using a flathead screwdriver.

Fig 1: Prying Up Hook Of Clip Using Flathead Screwdriver

Courtesy of MAZDA MOTORS CORP.

CAUTION:

Do not remove the wiring harness protective tape. Otherwise, the wires could rub against the body, which could result in water penetration and electrical shorting.

Fig 2: Wiring Harness Protective Tape

Courtesy of MAZDA MOTORS CORP.