Tire Pressure Monitoring System Initialization Procedure: Notes

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

Perform the tire pressure monitoring system initialization when the following operations have been performed:
- Tire pressures have been adjusted
- Tires or wheels have been replaced
- Tires have been rotated
- DSC HU/CM replaced
- DSC HU/CM connector disconnected
- Battery replaced
- Negative battery cable is disconnected

NOTE:

The tire pressure monitoring system initialization can be performed using two types of procedures. If the procedure using the M-MDS is used, the mis-use prevention logic is disabled.