Using the M-MDS
WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the M-MDS to the DLC-2.
- After vehicle identification, select the following from the M-MDS initialization screen.
- "DataLogger"
- "Modules"
- "IC"
- Using "SPDMTR", verify that the displayed information is as indicated in the chart.
| M-MDS display | Instrument cluster display |
|---|---|
| 60 km/h | Speedometer needle moves to approx. 58-62 km/h {36-39 mph}. |
| 120 km/h | Speedometer needle moves to approx. 117-123 km/h {72.8-76.4 mph}. |
| Off | Speedometer needle moves to the bottommost position. |
- If the speedometer does not operate or the indication is not within the allowable range, inspect the DTC inspection for the following control module and the related wiring harnesses.
- PCM
- TCM (ATX)
- DSC HU/CM
- If the PCM, TCM (ATX), DSC HU/CM, and related wiring harnesses are normal, replace the instrument cluster.