LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> On-Board Diagnostic - Engine Control System (3 Of 5) >> DTC P130C-00; Pre-Ignition Detected >> Diagnostic Procedure

Diagnostic Procedure

DIAGNOSTIC PROCEDURE DESCRIPTION

STEP INSPECTION RESULTS ACTION
1 RECORD VEHICLE STATUS AT TIME OF DTC DETECTION TO UTILIZE WITH REPEATABILITY VERIFICATION
NOTE:
  • Recording can be facilitated using the screen capture function of the PC.
  • Record the FREEZE FRAME DATA/snapshot data on the repair order.
- Go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 VERIFY IF MALFUNCTION CAUSED BY ABNORMAL FUEL - Go to the next step.
4 VERIFY IF MALFUNCTION CAUSE WAS CORRECTED BY REFUELING Yes
NOTE:
  • A malfunction has occurred because carbon has accumulated in combustion chamber.
Overhaul the engine and remove the carbon in the combustion chamber.Go to the next step.
No Go to Step 6.
5 VERIFY DTC TROUBLESHOOTING COMPLETED Yes Repeat the inspection from Step 1.
Go to the next step.
No Go to the next step.
6 VERIFY AFTER REPAIR PROCEDURE Yes Go to the applicable DTC inspection.
(See DTC TABLE [PCM (SKYACTIV-G 2.0, SKYACTIV-G 2.5)] .)
No DTC troubleshooting completed.