LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> On-Board Diagnostic - Engine Control System (1 Of 5) >> DTC P013A-00: HO2S: Slow Response (During Transition From Rich To Lean)P013B-00: HO2S: Slow Response (During Transition From Lean To Rich) >> Repeatability Verification Procedure

Repeatability Verification Procedure

  1. Warm up the engine to allow the engine coolant temperature to reach 80 °C {176 °F} or more.
  2. Verify that OBD-II information (such as FREEZE FRAME DATA) has been obtained and recorded.
  3. Clear the DTC from the PCM memory using the M-MDS. (See CLEARING DTC [PCM (SKYACTIV-G 2.0, SKYACTIV-G 2.5)] .)
  4. Switch the ignition off.
  5. Drive the vehicle for 15 min at a speed of 40 km/h {25 mph} or more.
  6. Shift to 3rd gear and rapidly accelerate the vehicle to 60 km/h {37 mph}.
  7. Release the accelerator pedal and decelerate the vehicle to 40 km/h {25 mph}.
  8. Repeat Step  5 to  7 operations above 5 times.
  9. Try to reproduce the malfunction by driving the vehicle for5 min based on the values in the FREEZE FRAME DATA/snapshot data.
    NOTE:
    • Match the engine coolant temperature in the recorded FREEZE FRAME DATA/snapshot data, the vehicle speed, and engine speed values to the best extent possible while driving the vehicle.
scientia non olet · About LEMON Manuals