| DESCRIPTION |
Vehicle collision |
| DETECTION CONDITION |
Determination conditions |
- A collision signal from the SAS control module is received.
|
| Preconditions |
|
| Drive cycle |
|
| Self test type |
|
| Sensor used |
|
| FAIL-SAFE FUNCTION |
- Stops fuel injection control
- Stops fuel pump control
- Stops ignition control
- Stops engine coolant fan control
|
| VEHICLE STATUS WHEN DTCs ARE OUTPUT |
- Stops fuel pump operation when ignition is switched ON
- Delays starter operation during cranking for maximum 1.2 s.
|
| POSSIBLE CAUSE |
- Vehicle is involved in collision (collision signal from SAS control module is received)
- SAS control module malfunction
- PCM malfunction
|