LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - Overhaul - SKYACTIV-G - 2.5L >> Cylinder Head Assembly (II) >> HLA Assembly Note

HLA Assembly Note

  1. Perform HLA air bleeding using the following procedure:
    1. Put the HLA in a container filled with engine oil.
      CAUTION:
      • Do not insert the round bar firmly because the check ball spring force is extremely weak.
    2. While lightly pressing the check ball using a round bar (approx. 1.0 mm {0.039 in}  diameter), bleed air by moving the plunger up and down.
    3. Press the end of the plunger in the oil and verify that there is no rebounding feel.
      • If rebounding feel cannot be eliminated, replace the HLA.
  2. Install the HLAs to their original positions as before removal.
    Fig 1: Checking Ball Using Round Bar
    G08348132Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals