Cylinder Block Inspection
- Measure the cylinder block for distortion in six directions as shown in the figure using a straight edge and feeler gauge.
- If it exceeds the maximum specification, replace the cylinder block.
Maximum distortion, head gasket side of the cylinder block 0.10 mm {0.0039 in}
- Measure the cylinder bore diameter using the cylinder gauge. The measurement position is in the X and Y directions at a point 43.9 mm {1.73 in}
below the top surface of the cylinder as shown in the figure.
- If it is not within the specification, replace the cylinder block.
Standard cylinder bore diameter 89.000-89.030 mm {3.5040-3.5051 in}