Plate Assembly Note
CAUTION:
- Placing the crankshaft on a disassembly bench will deform or damage it because the plate for the crankshaft position sensor signal detection installed to the crankshaft is larger than the counterweight. Therefore, set wood blocks or similar objects on the both sides of the crankshaft so that the plate does not contact the disassembly bench directly when placing the crankshaft on it bench.
- Install the plate using the following procedure:
- Install the groove of the plate tooth to the position shown in the figure and temporarily tighten bolt A.
- Temporarily tighten the bolt B.
- Install bolt C and tighten the bolts to the specified tightening torque in the order of C, B, and A.
Tightening torque 20-26 N.m {2.1-2.6 kgf.m, 15-19 ft.lbf}