LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> Engine Mechanical >> Exhaust System >> Exhaust System Removal/Installation >> 2WD >> Insulator (rear) removal note

Insulator (rear) removal note

NOTE:
  • The insulator (rear) are installed using rivets.
  1. Push out the mandrel using a hammer and punch (2-2.8 mm {0.08-0.11 in} diameter).
    Fig 1: Pushing Out Mandrel Using Hammer And Punch
    G09074416Courtesy of MAZDA MOTORS CORP.
  2. Remove the flange using a drill (5 mm {0.20 in} drill bit).
    Fig 2: Removing Flange Using Drill
    G05981018Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals