Snap Ring, Tripod Joint Disassembly Note

CAUTION:

To prevent part damage, do not use a punch or similar tool to place alignment marks. Use paint.

Place alignment marks on the shaft and tripod joint.

Fig 1: Placing Alignment Marks On Shaft And Tripod Joint
Courtesy of MAZDA MOTORS CORP.
Remove the snap ring using snap ring pliers.

Fig 2: Removing Snap Ring Using Snap Ring Pliers
Courtesy of MAZDA MOTORS CORP.
CAUTION:
- When using the hammer and urethane bar or equivalent, be careful not to scratch the roller area so as to prevent damage to the part.
NOTE:
- If the tripod joint cannot be removed from the shaft, lightly tap the tripod joint evenly using a hammer and urethane bar or equivalent, and remove the tripod joint from the shaft.
Remove the tripod joint from the shaft.
Wipe off grease on the shaft and tripod joint using a clean rag.