Front Drive Shaft (Tripod Joint) Disassembly/Assembly: Notes

Special Service Tool (SST) 

49 H027 002 Bearing remover	Courtesy of MAZDA MOTORS CORP.	49 W032 310 Support block	Courtesy of MAZDA MOTORS CORP.	49 T025 001 Boot clamp crimpers	Courtesy of MAZDA MOTORS CORP.
49 UB71 525 Bearing installer	Courtesy of MAZDA MOTORS CORP.	49 0710 520 Bearing puller	Courtesy of MAZDA MOTORS CORP.	-

Replacement Part 

Boot band (transaxle side) Quantity: 2 Location of use:Boot (transaxle side)	Dust cover Quantity: 1 Location of use: Outer ring	Snap ring Quantity: 1 Location of use: Outer ring
Bearing Quantity: 1 Location of use:Outer ring	Snap ring Quantity: 1 Location of use: Tripod joint	Boot (transaxle side) Quantity: 1 Location of use: Front drive shaft (transaxle side)
Boot band (wheel side) Quantity: 2 Location of use: Boot (wheel side)	Boot (wheel side) Quantity: 1 Location of use: Front drive shaft (wheel side)	-

Oil and Chemical Type 

Grease

Type: Maintenance parts

1. Disassemble in the order shown in the figure.
2. Assemble in the reverse order of disassembly.