Diagnostic procedure

DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	VERIFY INITIALIZATION PROCEDURE Was the brake fluid pressure sensor initialization procedure been performed?	Yes	Go to the next step.
1		No	Perform the brake fluid pressure sensor initialization procedure, then go to the next step. (See DSC RELATED PARTS SENSOR INITIALIZATION PROCEDURE .)
2	VERIFY NO ABNORMALITY ON BRAKE FLUID PRESSURE SENSOR Clear the DTCs from the memory. (See CLEARING DTC [DYNAMIC STABILITY CONTROL (DSC)] .) Start the engine and drive the vehicle at 10 km/h {6.2 mph} or more. Are the same DTCs present?	Yes	Replace the DSC HU/CM, then go to the next step. (See DSC HU/CM REMOVAL/INSTALLATION .)
2		No	Go to the next step.
3	VERIFY THAT NO OTHER DTCS ARE PRESENT Are any other DTCs output?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [DYNAMIC STABILITY CONTROL (DSC)] .)
3		No	DTC troubleshooting completed.