Clearance Inspection

Remove the ABS wheel-speed sensor.
Measure the distance between the ABS wheel-speed sensor installation surface and the ABS sensor rotor. This is dimension A.

Fig 1: Measuring Distance Between ABS Wheel-Speed Sensor Installation Surface And ABS Sensor Rotor
Courtesy of MAZDA MOTORS CORP.
Calculate the clearance between the front ABS wheel-speed sensor and the ABS sensor rotor using the following formula:
Clearance (mm {IN}) = A-34.35 {1.352}
Verify that the clearance between the ABS sensor rotor and the ABS wheel-speed sensor is as indicated below.
- If there is any malfunction, replace it.
  Clearance
- 3-1.4 mm {0.02-0.05 in}