Diagnostic Procedure
DTC U2300-56; CONFIGURATION DATA UNMATCHED WITH INSTRUMENT CLUSTER - DIAGNOSTIC PROCEDURE
| Step | Inspection | Action | |
|---|---|---|---|
| 1 | VERIFY INSTRUMENT CLUSTER DTCs
|
Yes | Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [INSTRUMENT CLUSTER] ) |
| No | Go to the next step. | ||
| 2 | RESET INSTRUMENT CLUSTER CONFIGURATION DATA
|
Yes | Using the M-MDS, perform the instrument cluster configuration (using As-Built data) again, then go to the next step. (See INSTRUMENT CLUSTER CONFIGURATION (USING AS-BUILT DATA) .) |
| No | Go to Step 4. | ||
| 3 | VERIFY THAT REPAIRS HAVE BEEN COMPLETED
|
Yes | Replace the electric parking brake control module, then go to the next step. (See ELECTRIC PARKING BRAKE CONTROL MODULE REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 4 | VERIFY IF OTHER DTCs DISPLAYED
|
Yes | Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [ELECTRIC PARKING BRAKE] .) |
| No | DTC troubleshooting completed. | ||