LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Conventional Brake System >> Brake Switch Inspection

Brake Switch Inspection

CAUTION:
  • Inspect the brake switch with it installed to the brake pedal, otherwise the brake switch may not operate normally. If the brake switch is removed from the brake pedal, replace the brake switch with a new one.
  1. Remove the lower panel. (See LOWER PANEL REMOVAL/INSTALLATION .)
  2. Remove the front heat duct (LH). (See FRONT HEAT DUCT REMOVAL/INSTALLATION .)
  3. Disconnect the brake switch connector.
  4. Verify that the continuity is as indicated in the table.
    Fig 1: Brake Switch Connector Terminals
    G09075193Courtesy of MAZDA MOTORS CORP.
    Fig 2: Brake Switch Connector Terminals Continuity Chart
    G09075192Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals