Rear Sash Molding Installation

WARNING:

Using a utility knife with bare hands can cause injury. Always wear gloves when using a utility knife.

NOTE:

Double-sided adhesive tape has already been attached to the new front sash molding.

Remove any grease or dirt from the ornament installation surface of the liftgate.

Fig 1: Removing Double-Sided Adhesive Tape To Front Sash Molding
Courtesy of MAZDA MOTORS CORP.
Peel off the backing of the double-sided adhesive tape.
After aligning clip A to the rear sash molding installation hole, hook the rear sash molding tab to the rear door.

Fig 2: Aligning Clip To Rear Sash Molding Installation Hole
Courtesy of MAZDA MOTORS CORP.
Press in the rear sash molding in the direction of the arrow shown in the figure and attach clip B to the rear door.
CAUTION:
- Do not press the rear sash molding in any place other than the rubber areas.
Press in the rear sash molding in the direction of the arrow shown in the figure from vehicle front and install the tab to the rear door.
NOTE:
- After installing the rear sash molding, verify that tabs are connected properly to the rear door.