Diagnostic Procedure
DTC U3000-01;START STOP UNIT INTERNAL MALFUNCTION DIAGNOSTIC PROCEDURE
| Step | Inspection | Action | |
|---|---|---|---|
| 1 | VERIFY IF MALFUNCTIONING LOCATION IS START STOP UNIT DEPENDING ON REPEATABILITY
|
Yes | Replace the start stop unit, then Go to the next step. (See START STOP UNIT REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 2 | VERIFY IF OTHER DTCs DISPLAYED
|
Yes | Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [START STOP UNIT] .) |
| No | DTC troubleshooting completed. | ||