Diagnostic Procedure
DTC P0616-29; DOWNSTREAM SIDE OF STARTER RELAY SIGNAL MALFUNCTION DIAGNOSTIC PROCEDURE
| Step |
Inspection |
Action |
| 1 |
VERIFY PCM DTCs
|
Yes |
Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.
(See DTC TABLE [PCM (SKYACTIV-G 2.0, SKYACTIV-G 2.5)]
.) |
| No |
Go to the next step. |
| 2 |
VERIFY IF MALFUNCTIONING LOCATION IS PCM DEPENDING ON REPEATABILITY
- Clear the DTC for the start stop unit using the M-MDS. (See CLEARING DTC [START STOP UNIT] .)
- With the programmed remote transmitter in the vehicle, switch the ignition ON (engine off).
- Perform the following work 5 times or more.
- Depress the clutch pedal and release it. (MTX)
- Operate the selector lever to other than P and N position from P or N position and hold for 1 s or more. (ATX)
- Retrieve the start stop unit DTCs using the M-MDS. (See DTC INSPECTION [START STOP UNIT] .)
- Is the same DTC displayed?
|
Yes |
Replace the PCM, then Go to the next step.
(See PCM REMOVAL/INSTALLATION [SKYACTIV-G 2.0, SKYACTIV-G 2.5]
.) |
| No |
Go to Step 4. |
| 3 |
VERIFY THAT REPAIRS HAVE BEEN COMPLETED
- Clear the DTC for the start stop unit using the M-MDS. (See CLEARING DTC [START STOP UNIT] .)
- With the programmed remote transmitter in the vehicle, switch the ignition ON (engine off).
- Perform the following work 5 times or more.
- Depress the clutch pedal and release it. (MTX)
- Operate the selector lever to other than P and N position from P or N position and hold for 1 s or more. (ATX)
- Retrieve the start stop unit DTCs using the M-MDS. (See DTC INSPECTION [START STOP UNIT] .)
- Is the same DTC displayed?
|
Yes |
Repeat the inspection from Step 1.
|
| No |
Go to the next step. |
| 4 |
VERIFY IF OTHER DTCs DISPLAYED
- Are any other DTCs displayed?
|
Yes |
Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.
(See DTC TABLE [START STOP UNIT] .) |
| No |
DTC troubleshooting completed. |