DTC C0051-95; Steering Angle Sensor Assembly Malfunction: Notes
DTC C0051-95; STEERING ANGLE SENSOR ASSEMBLY MALFUNCTION DETECTION CONDITION AND POSSIBLE CAUSES
| Description |
Steering angle sensor assembly malfunction |
| Detection condition |
- Start stop unit receives the following signals with the ignition switched ON (engine off or on).
- Steering angle sensor assembly malfunction from electric power steering (EPS) control module for 1 s or more
- Improper assembly of steering angle sensor at 360°
- Steering wheel angle of 720° or more for 0.048 s or more
|
| Fail-safe |
Not applicable |
| Possible cause |
- DTCs are stored in the electric power steering (EPS) control module.
- Improper assembly of steering angle sensor
- Start stop unit malfunction
|
| System wiring diagram |
Not applicable |