Diagnostic Procedure

DTC B13D3-97; REMOTE TRANSMITTER REGISTRATION WORK NOT COMPLETED DIAGNOSTIC PROCEDURE

Step	Inspection		Action
1	VERIFY IMMOBILIZER SYSTEM RELATED DTCs Retrieve the start stop unit DTCs using the M-MDS. (See DTC INSPECTION [START STOP UNIT] .) Are immobilizer system related DTCs displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [START STOP UNIT] .)
1		No	Go to the next step.
2	REGISTER REMOTE TRANSMITTER Register the remote transmitter. (See IMMOBILIZER SYSTEM-RELATED PARTS PROGRAMMING .) Clear the DTC for the start stop unit using the M-MDS. (See CLEARING DTC [START STOP UNIT] .) Retrieve the start stop unit DTCs using the M-MDS. (See DTC INSPECTION [START STOP UNIT] .) Is the same DTC displayed?	Yes	Go to the next step.
2		No	Go to Step 5.
3	PERFORM START STOP UNIT CONFIGURATION (USING AS-BUILT DATA) Using the M-MDS, perform the start stop unit configuration (using As-Built data). (See START STOP UNIT CONFIGURATION (USING AS-BUILT DATA) .) Clear the DTC for the start stop unit using the M-MDS. (See CLEARING DTC [START STOP UNIT] .) Retrieve the start stop unit DTCs using the M-MDS. (See DTC INSPECTION [START STOP UNIT] .) Is the same DTC displayed?	Yes	Using the M-MDS, perform the start stop unit configuration (using As-Built data) again, then Go to the next step. (See START STOP UNIT CONFIGURATION (USING AS-BUILT DATA) .)
3		No	Go to Step 5.
4	VERIFY THAT REPAIRS HAVE BEEN COMPLETED Clear the DTC for the start stop unit using the M-MDS. (See CLEARING DTC [START STOP UNIT] .) Retrieve the start stop unit DTCs using the M-MDS. (See DTC INSPECTION [START STOP UNIT] .) Is the same DTC displayed?	Yes	Replace the start stop unit, then Go to the next step. (See START STOP UNIT REMOVAL/INSTALLATION .)
4		No	Go to the next step.
5	VERIFY IF OTHER DTCs DISPLAYED Are any other DTCs displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [START STOP UNIT] .)
5		No	DTC troubleshooting completed.