Auto-stop Operation Inspection

Connect the battery voltage to windshield wiper motor terminal A, connect the ground to motor terminal D, and operate the windshield wiper motor at low speed.

Fig 1: Connecting Battery Voltage To Windshield Wiper Motor Terminal A
Courtesy of MAZDA MOTORS CORP.
Disconnect the battery voltage from terminal A during windshield wiper LO operation, and stop the windshield wiper motor halfway.
Connect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
Switch the ignition ON (engine off or on).
After the windshield wiper motor auto-stop operation, verify that it stops at the park position.
- If there is any malfunction, replace the windshield wiper motor. (See WINDSHIELD WIPER MOTOR AND LINK REMOVAL/INSTALLATION .)