Washer Motor Inspection

Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
Remove the seal board upper. (See SEAL BOARD UPPER REMOVAL/INSTALLATION .)
Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION .)
Disconnect the washer motor connector from the washer motor.

Fig 1: Disconnecting Washer Motor Connector From Washer Motor
Courtesy of MAZDA MOTORS CORP.
Disconnect the windshield washer hose from the washer motor.
Disconnect the rear washer hose from the washer motor.
WARNING:
- Water sprayed on the battery and ground could cause electrocution. When performing the washer motor inspection, prepare a container to collect washer fluid and be careful not to spray washer fluid.
After connecting washer motor terminal A to the positive battery terminal, and terminal B to ground, verify that washer fluid sprays from the front side of the washer motor.

Fig 2: Connecting Washer Motor Terminal A To Positive Battery Terminal, And Terminal B To Ground
Courtesy of MAZDA MOTORS CORP.

Fig 3: Checking Washer Fluid Sprays From Front Side Of Washer Motor
Courtesy of MAZDA MOTORS CORP.
- If there is any malfunction, replace the washer motor. (See WASHER MOTOR REMOVAL/INSTALLATION .)
After connecting washer motor terminal B to the positive battery terminal, and washer motor terminal A to ground, verify that washer fluid sprays from the rear side of the washer motor.

Fig 4: Connecting Washer Motor Terminal B To Positive Battery Terminal, And Washer Motor Terminal A To Ground
Courtesy of MAZDA MOTORS CORP.

Fig 5: Checking Washer Fluid Sprays From Rear Side Of Washer Motor
Courtesy of MAZDA MOTORS CORP.
- If there is any malfunction, replace the washer motor. (See WASHER MOTOR REMOVAL/INSTALLATION .)