Rear Wiper And Washer Switch Inspection

Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION .)
Remove the wiper and washer switch. (See WIPER AND WASHER SWITCH REMOVAL/INSTALLATION .)
Use a tester to measure and verify that the continuity between the rear wiper and washer switch terminals is as indicated in the table.

Fig 1: Measuring Continuity Between Rear Wiper And Washer Switch Terminals Using Tester
Courtesy of MAZDA MOTORS CORP.
- If the continuity is not as indicated in the table, replace the wiper and washer switch. (See WIPER AND WASHER SWITCH REMOVAL/INSTALLATION .)
Fig 2: Replacing Wiper And Washer Switch
Courtesy of MAZDA MOTORS CORP.