Diagnostic Procedure
AUDIO UNIT DISPLAY NOT DISPLAYED (ENTERTAINMENT SYSTEM - WITHOUT CENTER DISPLAY) DIAGNOSTIC PROCEDURE
| Step | Inspection | Action | |
|---|---|---|---|
| 1 | INSPECT AUDIO UNIT CONNECTOR
|
Yes | Go to the next step. |
| No | Repair or replace the connector, then go to Step 3. | ||
| 2 | VERIFY IF MALFUNCTION CAUSE IS OPEN CIRCUIT IN WIRING HARNESS BETWEEN AUDIO UNIT AND BODY GROUND
|
Yes | Replace the audio unit, then go to the next step. (See AUDIO UNIT REMOVAL/INSTALLATION .) |
| No |
|
||
| 3 | VERIFY IF MALFUNCTION CAUSE IS CORRECTED
|
Yes | Troubleshooting completed. (Explain the contents of the servicing to the customer.) |
| No | Verify the malfunction symptom in the symptom troubleshooting chart and perform the other applicable malfunction diagnosis. (See SYMPTOM TROUBLESHOOTING [ENTERTAINMENT SYSTEM [WITHOUT CENTER DISPLAY]] .) |
||