Auxiliary Jack/USB Port/SD Card Slot Hub Inspection

NOTE:

The integrity of the auxiliary jack/USB port/SD card slot hub cannot be determined by a single unit inspection. When inspecting the auxiliary jack/USB port/SD card slot hub, perform the following procedure.

Connect the M-MDS to the DLC-2.
Perform the connectivity master unit (CMU) DTC inspection and verify if DTCs related to the auxiliary jack/USB port/SD card slot hub are detected. (See DTC INSPECTION [CONNECTIVITY MASTER UNIT] .)
- If DTCs are detected, repair the malfunctioning location according to the applicable DTC troubleshooting. (See DTC TABLE [CONNECTIVITY MASTER UNIT] .)
- If DTCs are not detected, repair the malfunctioning location according to the symptom troubleshooting. (See SYMPTOM TROUBLESHOOTING [ENTERTAINMENT SYSTEM [WITH CENTER DISPLAY]] .)