Diagnostic procedure

BLIND SPOT MONITORING (BSM) OFF INDICATOR LIGHT ILLUMINATES CONTINUOUSLY (BLIND SPOT MONITORING (BSM) SYSTEM) DIAGNOSTIC PROCEDURE

Step	Inspection	Result	Action
1	INSPECT IF MALFUNCTION IS IN BLIND SPOT MONITORING (BSM) SWITCH OR INSTRUMENT CLUSTER Monitor the blind spot monitoring (BSM) control module (RH) PID BSM_OFF_IL using the M-MDS. (See PID/DATA MONITOR TABLE [BLIND SPOT MONITORING (BSM) CONTROL MODULE] .) Turn the blind spot monitoring (BSM) switch on and off. (See i-ACTIVSENSE PERSONALIZATION FEATURES SETTING PROCEDURE .) Does the PID BSM_OFF_IL monitoring value turn on and off according to the blind spot monitoring (BSM) switch operation?	Yes	Go to Step 3.
1		No	Go to the next step.
2	INSPECT CONNECTIVITY MASTER UNIT (CMU) Retrieve DTCs from connectivity master unit (CMU) using the M-MDS. (See DTC INSPECTION [CONNECTIVITY MASTER UNIT] .) Are any DTCs displayed?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [CONNECTIVITY MASTER UNIT] .)
2		No	Go to the next step.
3	INSPECT IF MALFUNCTION IS IN INSTRUMENT CLUSTER OR BLIND SPOT MONITORING (BSM) CONTROL MODULE (RH) Turn on the blind spot monitoring (BSM) OFF indicator light using the M-MDS instrument cluster active command modes WL+IL. (See ACTIVE COMMAND MODES INSPECTION [INSTRUMENT CLUSTER] .) Does the blind spot monitoring (BSM) OFF indicator light illuminate according to the active command modes?	Yes	Replace the blind spot monitoring (BSM) control module. (See BLIND SPOT MONITORING (BSM) CONTROL MODULE REMOVAL/INSTALLATION .)
3		No	Replace the instrument cluster. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .)