DTC Test [Radar Unit]: Notes
- Connect the M-MDS to the DLC-2.
- After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
- Select "Self Test".
- Select "All CMDTCs".
- Verify the DTC according to the directions on the screen.
- If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection after recording the snapshot data. (See DTC TABLE [RADAR UNIT] .)
- After completion of repairs, clear all DTCs stored in the radar unit. (See CLEARING DTC [RADAR UNIT] .)