Diagnostic Procedure
DIAGNOSTIC PROCEDURE
| Step | Inspection | Action | |
|---|---|---|---|
| 1 | VERIFY INSTRUMENT CLUSTER DTCs
|
Yes | Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [INSTRUMENT CLUSTER] .) |
| No | Go to the next step. | ||
| 2 | RESET CONFIGURATION DATA FROM INSTRUMENT CLUSTER TO RADAR UNIT
|
Yes | Using the M-MDS, perform the instrument cluster configuration (using As-Built data) again, then go to Step 4. (See INSTRUMENT CLUSTER CONFIGURATION (USING AS-BUILT DATA) .) |
| No | Go to the next step. | ||
| 3 | VERIFY PART NUMBER OF RADAR UNIT
|
Yes | Install the radar unit, then go to the next step. (See RADAR UNIT REMOVAL/INSTALLATION .) |
| No | Replace the radar unit, then go to the next step. (See RADAR UNIT REMOVAL/INSTALLATION .) |
||
| 4 | VERIFY THAT REPAIRS HAVE BEEN COMPLETED
|
Yes | Repeat the inspection from Step 1.
Go to the next step. |
| No | Go to the next step. | ||
| 5 | VERIFY IF OTHER DTCs DISPLAYED
|
Yes | Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [RADAR UNIT] .) |
| No | DTC troubleshooting completed. | ||