Diagnostic Procedure
DTC U2300:54 DIAGNOSTIC PROCEDURE
| Step | Inspection | Action | |
|---|---|---|---|
| 1 | VERIFY INSTRUMENT CLUSTER DTCs
|
Yes | Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [INSTRUMENT CLUSTER] .) |
| No | Go to the next step. | ||
| 2 | RESET INSTRUMENT CLUSTER CONFIGURATION DATA
|
Yes | Using the M-MDS, re-perform the instrument cluster configuration using the As-Built data, then go to the next step. (See INSTRUMENT CLUSTER CONFIGURATION (USING AS-BUILT DATA) .) |
| No | Go to Step 4. | ||
| 3 | VERIFY THAT REPAIRS HAVE BEEN COMPLETED
|
Yes | Replace the connectivity master unit (CMU), then go to the next step. (See CONNECTIVITY MASTER UNIT (CMU) REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 4 | VERIFY IF OTHER DTCs DISPLAYED
|
Yes | Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [CONNECTIVITY MASTER UNIT] .) |
| No | DTC troubleshooting completed. | ||