Diagnostic Procedure
DTC B108E:04 DIAGNOSTIC PROCEDURE
| Step | Inspection | Action | |
|---|---|---|---|
| 1 | PERFORM DTC INSPECTION AND VERIFY IF MALFUNCTIONING LOCATION IS CENTER DISPLAY
|
Yes | Replace the center display, then go to the next step. (See CENTER DISPLAY REMOVAL/INSTALLATION .) |
| No | Go to Step 3. | ||
| 2 | VERIFY THAT REPAIRS HAVE BEEN COMPLETED
|
Yes | Replace the connectivity master unit (CMU), then go to the next step. (See CONNECTIVITY MASTER UNIT (CMU) REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 3 | VERIFY IF OTHER DTCs DISPLAYED
|
Yes | Repair the malfunctioning location according to the applicable DTC troubleshooting. (See DTC TABLE [CONNECTIVITY MASTER UNIT] .) |
| No | DTC troubleshooting completed. | ||