LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> On-Board Diagnostic - Audio >> DTC: 26-Er82; MICROPHONE CIRCUIT MALFUNCTION >> Diagnostic Procedure

Diagnostic Procedure

DIAGNOSTIC PROCEDURE

Step Inspection Action
1 INSPECT MICROPHONE CONNECTOR CONDITION
  • Switch the ignition off.
  • Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  • Disconnect the microphone connector.
  • Inspect the connector engagement and connection condition and inspect the terminals for damage, deformation, corrosion, or disconnection.
  • Is there any malfunctioning part?
 Yes Repair or replace the connector, then go to Step 5.
No Go to the next step.
2 INSPECT Bluetooth ® UNIT CONNECTOR CONDITION
  • Disconnect the Bluetooth ® unit connector.
  • Inspect the connector engagement and connection condition and inspect the terminals for damage, deformation, corrosion, or disconnection.
  • Is there any malfunctioning part?
 Yes Repair or replace the connector, then go to Step 5.
No Go to the next step.
3 INSPECT FOR SHORT TO POWER SUPPLY IN MICROPHONE INPUT CIRCUIT
  • Always reconnect all disconnected connectors.
  • Connect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  • Switch the ignition ON (engine off or on).
  • Measure the voltage of Bluetooth ® unit terminal A (wiring harness-side).
  • Is the voltage B+?
 Yes Refer to the wiring diagram and verify whether or not there is a common connector between Bluetooth ® unit terminal A and microphone terminal A. If there is a common connector:
  • Determine the malfunctioning part by inspecting the common connector and the terminal for corrosion, damage, or pin disconnection, and the common wiring harness for a short to power supply.
  • Repair or replace the malfunctioning part.

    If there is no common connector:

  • Repair or replace the wiring harness which has a short to power supply.

Go to Step 5.
No Go to the next step.
4 VERIFY IF MALFUNCTIONING LOCATION IS MICROPHONE DEPENDING ON REPEATABILITY Yes Replace the microphone, then go to the next step.
(See MICROPHONE REMOVAL/INSTALLATION .)
No Go to Step 6.
5 VERIFY THAT REPAIRS HAVE BEEN COMPLETED Yes Repeat the inspection from Step 1.
Go to the next step.
No Go to the next step.
6 VERIFY IF OTHER DTCs DISPLAYED
  • Are any other DTCs displayed?
 Yes Repair the malfunctioning part according to the applicable DTC troubleshooting.
(See DTC TABLE [AUDIO UNIT] .)
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals