Diagnostic Procedure
DTC C0051-28; C0051-54; C0051-64; STEERING ANGLE SIGNAL MALFUNCTION DIAGNOSTIC PROCEDURE
| Step | Inspection | Action | |
|---|---|---|---|
| 1 | VERIFY EPS CONTROL MODULE DTC
|
Yes | Go to the applicable DTC inspection. (See DTC TABLE [EPS CONTROL MODULE]
.) DTC troubleshooting completed, then go to the next step. |
| No | Go to the next step. | ||
| 2 | VERIFY DTC TROUBLESHOOTING COMPLETED
|
Yes | Repeat the inspection from Step1 If the malfunction recurs, replace the DSC HU/CM, then go to the next step. (See DSC HU/CM REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 3 | VERIFY NO DTC IS PRESENT
|
Yes | Go to the applicable DTC inspection. (See DTC TABLE [DSC HU/CM] .) |
| No | DTC troubleshooting completed. | ||