Diagnostic Procedure

DTC C0001-01; C0001-49; C0003-01; C0003-49; STABILITY CONTROL SOLENOID VALVE MALFUNCTION DIAGNOSTIC PROCEDURE

Step	Inspection		Action
1	VERIFY STABILITY CONTROL SOLENOID VALVE OPERATION Using the M-MDS, perform the simulation inspection for stability control solenoid valve. (See SIMULATION INSPECTION [DSC HU/CM] .) Does the solenoid valve operate?	Yes	Go to the next step.
1		No	Replace the DSC HU/CM, then go to the next step. (See DSC HU/CM REMOVAL/INSTALLATION .)
2	VERIFY DTC TROUBLESHOOTING COMPLETED Using the M-MDS, clear the DTC from the DSC HU/CM. (See CLEARING DTC [DSC HU/CM] .) Using the M-MDS, perform the DSC HU/CM DTC inspection. (See DTC INSPECTION [DSC HU/CM] .) Is the same DTC present?	Yes	Repeat the inspection from Step1. If the malfunction recurs, replace the DSC HU/CM, then go to the next step. (See DSC HU/CM REMOVAL/INSTALLATION .)
2		No	Go to the next step.
3	VERIFY NO DTC IS PRESENT Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [DSC HU/CM] .)
3	VERIFY NO DTC IS PRESENT Are any DTCs present?	No	DTC troubleshooting completed.