Diagnostic Procedure

DTC U2300-54; U2300-55; U2300-56; U2300-64; CONFIGURATION ERROR DIAGNOSTIC PROCEDURE

Step	Inspection		Action
1	RECORD CONFIGURATION DATA Switch the ignition OFF. Switch the ignition ON (engine off), and maintain this condition for approx. 10 s or more. Switch the ignition OFF, and maintain this condition for approx. 3 s or more. Switch the ignition ON (engine off), and maintain this condition for approx. 3 s or more.		Go to the next step.
2	VERIFY DSC HU/CM DTC Using the M-MDS, clear the DTC from the DSC HU/CM. (See CLEARING DTC [DSC HU/CM] .) Using the M-MDS, perform the DSC HU/CM DTC inspection. (See DTC INSPECTION [DSC HU/CM] .) Are any DTCs present?	Yes	Repeat the inspection from Step1. If the malfunction recurs, go to the next step.
2		No	Go to Step 6.
3	VERIFY IF PARTS FROM ANOTHER VEHICLE INSTALLED TO INSTRUMENT CLUSTER, PCM OR DSC HU/CM Verify if an instrument cluster, PCM or DSC HU/CM from another vehicle is installed. Has an instrument cluster, PCM, DSC HU/CM or other vehicle part been installed to vehicle?	Yes	Install the correct instrument cluster, PCM or DSC HU/CM, then go to Step1. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .) (See PCM REMOVAL/INSTALLATION [SKYACTIV-G 2.0] .) (See DSC HU/CM REMOVAL/INSTALLATION .)
3		No	Go to the next step.
4	VERIFY INSTRUMENT CLUSTER AND PCM DTC Using the M-MDS, perform the instrument cluster and PCM DTC inspection. (See DTC INSPECTION [INSTRUMENT CLUSTER] .) (See ON-BOARD DIAGNOSTIC TEST [SKYACTIV-G 2.0] .) Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [INSTRUMENT CLUSTER] .) (See DTC TABLE [SKYACTIV-G 2.0] .) DTC troubleshooting completed, then go to the next step.
4		No	Go to the next step.
5	VERIFY DSC HU/CM DTC Using the M-MDS, clear the DTC from the DSC HU/CM. (See CLEARING DTC [DSC HU/CM] .) Using the M-MDS, perform the DSC HU/CM DTC inspection. (See DTC INSPECTION [DSC HU/CM] .) Are any DTCs present?	Yes	Repeat the inspection from Step1. If the malfunction recurs, replace the DSC HU/CM, then go to the next step. (See DSC HU/CM REMOVAL/INSTALLATION .)
5		No	Go to the next step.
6	VERIFY NO DTC IS PRESENT Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [DSC HU/CM] .)
6	VERIFY NO DTC IS PRESENT Are any DTCs present?	No	DTC troubleshooting completed.