Diagnostic Procedure

DTC C0061-28; C0061-54; C0061-64; LATERAL-G SENSOR SIGNAL OUTSIDE OF SPECIFIED VALUE DIAGNOSTIC PROCEDURE

Step	Inspection		Action
1	VERIFY LOW-G SENSOR INITIALIZATION Has the low-G sensor initialization procedure been performed?	Yes	Go to the next step.
1		No	Perform the low-G sensor initialization procedure, then go to the next step. (See DSC RELATED PARTS SENSOR INITIALIZATION PROCEDURE .)
2	VERIFY SAS CONTROL MODULE DTC Using the M-MDS, perform the SAS control module DTC inspection. (See DTC INSPECTION [SAS CONTROL MODULE (STANDARD DEPLOYMENT CONTROL SYSTEM)] .) (See DTC INSPECTION [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM)] .) Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [SAS CONTROL MODULE (STANDARD DEPLOYMENT CONTROL SYSTEM)] .) (See DTC TABLE [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM)] .) DTC troubleshooting completed, then go to the next step.
2		No	Go to the next step.
3	VERIFY DTC TROUBLESHOOTING COMPLETED Using the M-MDS, clear the DTC from the DSC HU/CM. (See CLEARING DTC [DSC HU/CM] .) Using the M-MDS, perform the DSC HU/CM DTC inspection. (See DTC INSPECTION [DSC HU/CM] .) Is the same DTC present?	Yes	Repeat the inspection from Step1 If the malfunction recurs, replace the DSC HU/CM, then go to the next step. (See DSC HU/CM REMOVAL/INSTALLATION .)
3		No	Go to the next step.
4	VERIFY NO DTC IS PRESENT Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [DSC HU/CM] .)
4	VERIFY NO DTC IS PRESENT Are any DTCs present?	No	DTC troubleshooting completed.