DTC C0051-28; C0051-54; C0051-64; Steering Angle Signal Malfunction: Notes
DTC C0051-28; C0051-54; C0051-64; STEERING ANGLE SIGNAL MALFUNCTION DETECTION CONDITION AND POSSIBLE CAUSE
| DTC |
C0051:28 |
Steering angle signal |
| C0051:54 |
| C0051:64 |
| DETECTION CONDITION |
- C0051:28
- Steering angle signal malfunction is detected.
- C0051:54
- No determination of steering angle neutral position.
NOTE:
- Each time the ignition is switched ON, the DSC HU/CM and EPS control module individually calculates the steering angle neutral position based on the signals from each sensor and each module.
- If the vehicle is driven as follows just after the engine is started, the DSC HU/CM may store DTC C0051:54.
- Vehicle is accelerated rapidly while being steered left or right.
- Vehicle is driven on a banked road.
- Vehicle is steered left and right repeatedly.
- If the DTC is a past malfunction during DTC inspection, it does not indicate a vehicle malfunction.
- C0051:64
- Difference between steering angle calculated by each sensor and steering angle received from EPS control module outside of specified value is detected.
|
| FAIL-SAFE FUNCTION |
|
| POSSIBLE CAUSE |
- EPS control module malfunction
- DSC HU/CM malfunction
|
| SYSTEM WIRING DIAGRAM |
- |