Front Side

Open the front door.
Affix the protective tape to the position shown in the figure to prevent scratches and damage.

Fig 1: Affixing Protective Tape
Courtesy of MAZDA MOTORS CORP.
Remove the hole cover. (With hole cover)

Fig 2: Removing Hole Cover
Courtesy of MAZDA MOTORS CORP.
Insert the flathead screwdriver in the position shown in the figure and detach the side garnish clip. (With hole cover)

Fig 3: Detaching Side Garnish Clip
Courtesy of MAZDA MOTORS CORP.
To prevent scratches or damage, affix protective tape to the position shown in the figure of the front door panel. (Without hole cover)

Fig 4: Affixing Protective Tape
Courtesy of MAZDA MOTORS CORP.
Insert remover tool A into the position shown in the figure. (Without hole cover)

Fig 5: Inserting Remover Tool A
Courtesy of MAZDA MOTORS CORP.
Insert remover tool B into the position shown in the figure. (Without hole cover)

Fig 6: Inserting Remover Tool B
Courtesy of MAZDA MOTORS CORP.
Pull out remover tool A. (Without hole cover)
Insert a flathead screwdriver into the gap made by remover tool A. (Without hole cover)

Fig 7: Inserting Flathead Screwdriver Into Gap
Courtesy of MAZDA MOTORS CORP.
Move the flathead screwdriver in the direction of the arrow shown in the figure and detach the clip of side garnish from the front door. (without hole cover)
Pull the side garnish in the direction of arrow (2) shown in the figure while pulling it in the direction of arrow (1) to remove it.

Fig 8: Detaching Clip Of Side Garnish From Front Door
Courtesy of MAZDA MOTORS CORP.
Remove the clips from the front door.

Fig 9: Removing Clips From Front Door

Courtesy of MAZDA MOTORS CORP.